Iron on! RHINESTONE INSTRUCTIONS: 1. Preheat iron to cotton setting. 2. Put cardboard in between shirt so the rhinestone glue doesn’t go through to the back of the shirt. OR use the parchment paper sent with this order 3. Peel off textured backing from the design (stones should stick to the clear plastic sheet). If any stones have shifted out of place, put them back in place using tweezers OR move them with your finger nail . 4. Place plastic sheet, stone side down on fabric and press into place with hand. The clear plastic sheet should stick to the fabric. 5. Place iron over design area and apply steady pressure for 15 seconds - DO NOT MOVE IRON AROUND AS STONES MAY SHIFT – DO NOT USE AN IRONING BOARD. YOU NEED A HARD FLAT SURFACE 6. Turn Garment WRONG SIDE OUT and Place iron over design area for another 15 seconds and repeat. 7. Set aside and allow to cool for 3 to 5 minutes. 8. Turn fabric to right side out. Slowly and carefully peel the clear plastic sheet away from the fabric. If all stones are not sticking, you may re-iron on the opposite side of the fabric again. Best Care: Wash inside out and air dry. *****Wear To Start is NOT responsible for garments for any reason. Look over carefully prior to ironing. Make sure the back of the transfer is free of plastic or debris. Use tweezers to remove any unwanted materials that might have been missed from the transfer, or to put the rhinestone back in place if they moved from original location on the carrier.****