Skeleton rib cage in clear hot fix crystals. Iron on to your own garments to make your own statements! RHINESTONE INSTRUCTIONS: 1. Preheat iron to cotton setting. Heat Press 320 2. Put cardboard in between shirt so the rhinestone glue doesn’t go through to the back of the shirt. OR the parchment paper sent with this order 3. Peel off textured backing from the design (stones should stick to the clear plastic sheet). If any stones have shifted out of place, put them back in place using tweezers. 4. Place plastic sheet, stone side down on fabric and press into place with hand. The clear plastic sheet should stick to the fabric. 5. Place iron over design area and apply steady pressure for 15 seconds - DO NOT MOVE IRON AROUND AS STONES MAY SHIFT – 6. Turn Garment WRONG SIDE OUT and Place iron over design area for another 15 seconds and repeat. 7. Set aside and allow to cool for 3 to 5 minutes. 8. Turn fabric to right side out. Slowly and carefully peel the clear plastic sheet away from the fabric. If all stones are not sticking, you may re-iron on the opposite side of the fabric again. *** These hot fix and iron on rhinestones and transfers are not intended for use by or near small children. Please do not allow children access to these products. *****Wear To Start is NOT responsible for garments for any reason. Look over carefully prior to ironing. Make sure the back of the transfer is free of plastic or debris. Use tweezers to remove any unwanted materials that might have be